How to Use BIAS Footswitch with BIAS Head/Rack?

BIAS Head
Using a TRS cable, connect your BIAS Footswitch to FOOTSWITCH jack 1 on the back of your BIAS Head.
Screen_Shot_2017-11-20_at_3.00.39_PM.png

BIAS Rack
Using a TRS cable, connect your BIAS Footswitch to EXP. PEDAL jack 1 on the back of your BIAS Rack.

Screen_Shot_2017-11-20_at_3.01.08_PM.png

Once you have connected your BIAS Footswitch to BIAS Head/Rack, follow the steps below to finish the set up:

1. Hold the F1 switch (calibration switch) on the rear of the unit for 3 seconds, until the LED lights up Blue in color.
2. Choose the amp preset you’d like to use with your BIAS Footswitch.
3. Step on the toggle switch (1-4) that you’d like to use on BIAS Footswitch, the LED will flash Red in color a few times to indicate that the calibration was successful.
4. Flick the calibration switch twice on the rear of the unit to finish the calibration, the F1 switch LED will flash Red in color a few times to indicate that the current preset will be saved with the footswitch value.

Please Note: BIAS Footswitch works with FOOTSWITCH jack 1/EXP. PEDAL jack 1 on BIAS Head/Rack ONLY. BIAS Footswitch is not compatible with FOOTSWITCH jack 2/EXP. PEDAL jack 2.

Was this article helpful?
0 out of 0 found this helpful
Need More Help? Contact Us

Comments