Working with Mixer / DI / Active speaker (Line outs)  

Working with Mixer / DI / Active speaker (Line outs)    

To connect to an active speaker, PA or DI out:

  1. Connect your instrument to the input jack
  2. Connect the equipment to the line out TS jack or XLR 

There are both balanced (3-pin XLR) and unbalanced (TS ¼ inch jack) outputs on the rear of the BIAS Head/BIAS Rack unit. Unbalanced connections are usually adequate for home studio and stage rigs where there are no long cable runs, but it’s recommend. But if you need lengthy cables in your setup, balanced connections will help keep your output signal noise-free.

There is also a Ground Lift function available to reduce/eliminate any unwanted hum from ground-related noise (usually occurs if two or more pieces of equipment are connected).

 

Was this article helpful?
1 out of 1 found this helpful
Need More Help? Contact Us

Comments

Article is closed for comments.