1. Help Center
  2. Spark LINK
  3. Troubleshooting

Re-Pairing / Reset for Spark LINK

A reset clears the pairing between your Spark LINK TX and RX units, restoring them to their default state. This is recommended if the units fail to connect automatically or you need to re-pair from scratch.

This will permanently erase:
  • TX/RX pairing information

Spark LINK — Reset

  1. Press and hold the Reset Button, then plug the charging cable into the USB port.
  2. Wait 5 seconds, then release the Reset Button. Unplug the USB charging cable.
  3. Repeat steps 1–2 3 to 5 times until the red charging LED lights up. Once it does, release the Reset Button — the unit has been successfully reset.
  4. Repeat the same steps for the other unit (TX or RX).
  5. Power on the TX first, then the RX. Both LEDs will flash blue while pairing and turn solid once successfully paired.
Was this article helpful?
0 out of 0 found this helpful
Still need help?
Our support team can help answer questions and solve problems.
Contact Support
Contact Support