1. Help Center
  2. Spark CAB 2
  3. How to (User manual)

Using Spark CAB 2 as an Output to a PA System

← Back to Spark CAB 2 User Guide

Send Spark CAB 2's signal to a PA system through the balanced XLR Output. The Line Out Volume controls the output level independently of the speaker volume.

Connection Steps

  1. Make sure the Line Out Volume of Spark CAB 2 and the levels of the PA system are turned down.

  2. Connect the Output of Spark CAB 2 to the input of the PA system with a standard XLR cable (not included).

    XLR Output and Line Out on Spark CAB 2 rear panel

    XLR Output on Spark CAB 2

  3. Start adjusting the Line Out Volume of Spark CAB 2 and the levels of the PA system as needed.

If you hear unwanted hum or noise, engage the Ground Lift Switch on the rear panel.

Was this article helpful?
0 out of 0 found this helpful
Still need help?
Our support team can help answer questions and solve problems.
Contact Support
Contact Support