How to use Auto Tone

  1. Go to the Music page and tap on the Experience Jimi Hendrix™ banner at the top of the page.
  2. You may access the songs that have Auto Tone enabled by:
    • Going into any of the articles featured in Famous Moments and scrolling down to the bottom of the page
    • Going into any of the articles featured in Jimi’s Gear; if the gear was used in the creation of the tone for a song with Auto Tone enabled, it will show up at the bottom of the page
    • Playing any of the songs listed at the bottom of the Experience Jimi Hendrix™ page under Auto Tone
  3. Tapping into the song, Spark will take a few seconds to load the presets. Once all the presets are loaded, the song will begin to play. Play along with the song and once the red circle on screen becomes connected, the next tone will be loaded.
  4. To turn off Auto Tone, tap the Auto Tone slider at the bottom of the song detail page, or if you’re on a different menu, tap the X on the right side of the global player at the bottom of the screen to close the song and revert to your previously loaded preset. You may also turn off Auto Tone from the amp control menu.
Was this article helpful?
0 out of 0 found this helpful
Need More Help? Contact Us