Use Looper with the Spark app (Spark EDGE)

The Spark EDGE has a built-in looper to further enhance your playing experience. When connected to the app, not only will you get to control the looper via your phone, but there will be more settings available for you to adjust.

Simple Looper

Make sure you are connected to your Spark device’s Bluetooth Audio and Tone Control connections, and ensure that your phone’s volume is also turned up, then tap on the Music page and tap on the Simple Looper banner.
(A) Looper Settings - tap on this area to access looper settings to adjust parameters.
(B) Undo/Redo Button - removes or restores last recorded dub layer
(C) Record/Dub Button, Progress Circle - start recording or dubbing, see how much time is left before the loop repeats
(D) Mixer Button - Adjust loop and click volume
(E) Discard Button - discards current loop if present

The looper can record up to 60 seconds, and one loop can be stored on the Spark device at a time.

Groove Looper

Groove Looper expands on the looper function even further, with realistic drums to accompany your loops to further immerse you in your own music.

Make sure you are connected to your Spark device’s Bluetooth Audio and Tone Control connections, and ensure that your phone’s volume is also turned up, then tap on the Music page and tap on the Groove Looper banner.

(A) Looper Settings - tap on this area to access looper settings to adjust parameters.
(B) Drum Selection Menu - add drum patterns to your loop
(C) Undo/Redo Button - removes or restores last recorded dub layer
(D) Record/Dub Button - start recording or dubbing
(E) Mixer Button - Adjust loop and click volume
(F) Discard Button - discards current loop if present